CAREU Ucan

Manufacturer:

CAREU Ucan is an OBDII-type GPS tracker for fleet management solutions supporting communication via UMTS/HSPA/GPRS/EDGE, featuring remote configuration, intelligent power management, built-in backup battery, geofencing, and a lot more. Also, CAREU Ucan supports FOTA firmware via FTP

CAREU Ucan description

CAREU Ucan is an OBDII-type GPS tracker for fleet management solutions supporting communication via UMTS/HSPA/GPRS/EDGE, featuring remote configuration, intelligent power management, built-in backup battery, geofencing, and a lot more. Also, CAREU Ucan supports FOTA firmware via FTP

Location and tracking

  • GPS
  • Interval and continuous tracking modes

Mobile networks

  • 2G/GSM: Quad band, 850/900/1800/1900 MHz
  • 3G/ UMTS/HSPA: 850/900/1900/2100 MHz

Interfaces

  • OBD II
  • External CAN interface

Power supply

  • 8-30V DC

Features

  • Support engine/ignition status detection
  • Support harsh acceleration/ harsh braking/impact detection/ harsh cornering/ flip over detection
  • Remote configuration
  • Intelligent power management
  • Assisted-GPS

Specifications and Features

Supported features

Server Integration
Server IP Address217.23.132.215
Server port46986
General information
PurposeVehicle
InstallationDIY
Housing
Weight60 g (2.12 oz.)
Size48x66x25 mm (1.89x2.6x0.98 in)
GNSS Location
Internal antenna (GNSS)
GPS
Assisted GPS
Connectivity
Cellular network typeGSM 850/900/1800/1900, HPSA/UMTS 850/900/1900/2100
Internal antenna (Connection)
Cellular network generation2G, 3G
Interfaces
Number of inputs (all types)1
ACC/Ignition inputFeature already supported
Feature already supported in
Discrete inputsFeature already supported
Feature already supported in
Analog inputsFeature already supported
Feature already supported in
Tracking features
Tracking modesContinuous, Interval
Feature already supported in
OdometerFeature already supported
Feature already supported in
ECO drivingFeature already supported
Feature already supported in
Events monitoring
Battery lowFeature already supported
Feature already supported in
External power cut offFeature already supported
Feature already supported in
Car crashFeature already supported
Feature already supported in
Device switched on/offFeature already supported
Feature already supported in
Self monitoring
GNSS signal levelFeature already supported
Feature already supported in
External power source voltageFeature already supported
Feature already supported in
Internal battery levelFeature already supported
Feature already supported in
CAN/OBDII reading
CAN/OBDII reader typeExternalFeature already supported
Feature already supported in
Remote management
Server connection setup over SMSFeature already supported
Feature already supported in
Remote device configurationYes (over GPRS)Feature already supported
Feature already supported in

Server software

Navixy

Server Integration
Server IP Address217.23.132.215
Server port46986

Automatic activation (recommended)

The software platform supports automatic device activation by applying APN settings, server address and port, as well as recommended tracking mode though the SMS channel. Normally you don’t need to configure anything manually. Just install the SIM card, switch the device ON and make sure it is located in the place with good GPS signal reception.

You also need to keep the device with initial factory settings, in particular:

  • Do not set any password, keep it clear (as by default)
  • Do not set any master number prior to the device activation
  • Do not set local Time zone, it must be UTC+0h (as by default)

Manual activation

In case automatic activation failed, you can try to register the device manually by sending SMS/GPRS commands to the device.

SMS commands:

AT$MODID=1234567890
AT$APN={apn},{apn_user},{apn_pass}
AT$HOSTS=1,0,{server_ip},46986
AT$SAVE

The <APN> parameters depend on your GSM carrier.

Reviews

There are no reviews yet.

Be the first to review “CAREU Ucan”