cGuard Beacon

Manufacturer:

cGuard Beacon is a compact GLONASS/GPS asset tracker with a powerful internal battery and built-in GSM and GPS antennas. With the help of 14000 mAh internal battery, device can be used for various objects monitoring for a long time. cGuard Beacon is a small sized device with IP67 protection, which supports OTA firmware upgrade.

cGuard Beacon description

cGuard Beacon is a compact GLONASS/GPS asset tracker with a powerful internal battery and built-in GSM and GPS antennas. With the help of 14000 mAh internal battery, device can be used for various objects monitoring for a long time. cGuard Beacon is a small sized device with IP67 protection, which supports OTA firmware upgrade.

Features

  • Dual SIM. The main SIM card must be installed in the SIM2 slot.
  • Supports A-GPS, has built-in accelerometer.
  • The built-in battery capacity is 14000 mAh (up to 5 years of battery life in interval mode).
  • Can work in continuous tracking mode and in interval mode.

Location and tracking

  • GPS, GLONASS support
  • LBS support

Mobile networks

  • 850/900/1800/1900 MHz
  • 2G Network

Power supply

  • Build-in battery (14000 mAh)

Other features

  • Remote management
  • IP67 protection

Specifications and Features

Supported features

Server Integration
Server IP Address217.23.132.215
Server port47729
General information
PurposeAsset
InstallationNot required
Housing
Weight210 g (7.41 oz.)
Size72x49x43 mm (2.83x1.93x1.69 in)
GNSS Location
Internal antenna (GNSS)
GPS
GLONASS
Connectivity
Cellular network typeGSM Quad Band
Internal antenna (Connection)
Cellular network generation2G
Tracking features
Tracking modesContinuous, Interval
Location by Cell IDFeature already supported
Feature already supported in
Events monitoring
Battery lowFeature already supported
Feature already supported in
Self monitoring
Network signal levelFeature already supported
Feature already supported in
GNSS signal levelFeature already supported
Feature already supported in
Internal battery levelFeature already supported
Feature already supported in
Remote management
Server connection setup over SMSFeature already supported
Feature already supported in
Remote device configurationYes (over GPRS)Feature already supported
Feature already supported in

Server software

Navixy

Server Integration
Server IP Address217.23.132.215
Server port47729

Automatic activation (recommended)

The software platform supports automatic device activation by applying APN settings, server address and port, as well as recommended tracking mode though the SMS channel. Normally you don’t need to configure anything manually. Just install the SIM card, switch the device ON and make sure it is located in the place with good GPS signal reception.

You also need to keep the device with initial factory settings, in particular:

  • Do not set any password, keep it clear (as by default)
  • Do not set any master number prior to the device activation
  • Do not set local Time zone, it must be UTC+0h (as by default)

Manual activation

In case automatic activation failed, you can try to register the device manually by sending following commands to the device:

PARAM_SET:APN_HOST:<apn_host>$
PARAM_SET:APN_USER:<apn_user>$
PARAM_SET:APN_PASSWORD:<apn_password>$
PARAM_SET:SERVER_HOST:<server_hostname>$
PARAM_SET:SERVER_POST:47729$

The <APN> parameters depend on your GSM carrier.

Reviews

There are no reviews yet.

Be the first to review “cGuard Beacon”